Individual pins can be cut out of the plastic mounts to use as individual pins or plugs. Look at the picture and you can see that there are 4 steps to using these pins.
Step 1 Shows the wire stripped, tinned, with a piece of 1/16 inch in diameter heat shrink tubing over the wire. The female end of the pin has been tinned.
Step 2 Shows that the wire has been soldered into the female end of the pin, and the heat shrink tubing shrunk into place. You now have a finished male plug ready for use.
Step 3 Shows a pin with the male end slightly clipped, (shown with a full lenght pin above it), and wire stripped tinned and tubing over it.
Step 4 Shows a finished female socket, that the wire has been soldered onto the male end of the pin, and the heat shrink tubing shrunk into place. The male pin in Step 2 will plug into the female in Step 4. DO NOT PLACE THIS LISTING INTO THE SHOPPING CART. IT IS MEANT AS A HELP ITEM ONLY. FEEL FREE TO DOWNLOAD THE PICTURES, AND OR DESCRIPTION.
